Difference between revisions of "TN1"
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
== Audio Configuration == |
== Audio Configuration == |
||
The IP-Phone-C SIP server only supports the G711u codec. Other codecs, or too many proposed codecs, may trigger a "488 Not Acceptable Here" response. Therefore configuration with just G711u is recommended. |
The IP-Phone-C SIP server only supports the G711u codec. Other codecs, or too many proposed codecs, may trigger a "488 Not Acceptable Here" response. Therefore configuration with just G711u is recommended. |
||
| − | |||
| − | Configure an extension as follows: |
||
EXT > Preferred Codec = G711u |
EXT > Preferred Codec = G711u |
||
EXT > Use Pref Codec Only = Yes |
EXT > Use Pref Codec Only = Yes |
||
| + | |||
| + | == NAT Configuration == |
||
| + | If you are using NAT, enable keepalives: |
||
| + | EXT > NAT Keep Alive Enable = Yes |
||
== RTP Packet Size == |
== RTP Packet Size == |
||
Revision as of 08:36, 30 December 2018
TN1: Configuring a SPA504g for use with IP-Phone-C
Subscriber Information
Configure an extension as follows:
EXT > Display Name = <Phone Number> EXT > User Id = <Phone Number> EXT > Password = <Password> EXT > Use Auth Id = Yes EXT > Auth Id = <User Id>
Audio Configuration
The IP-Phone-C SIP server only supports the G711u codec. Other codecs, or too many proposed codecs, may trigger a "488 Not Acceptable Here" response. Therefore configuration with just G711u is recommended.
EXT > Preferred Codec = G711u EXT > Use Pref Codec Only = Yes
NAT Configuration
If you are using NAT, enable keepalives:
EXT > NAT Keep Alive Enable = Yes
RTP Packet Size
The IP-Phone-C SIP server only accepts a SDP attribute a=ptime with the value 20. Any other value will result in a "488 Not Acceptable Here" response, incorporating a "307 Session description parameter not understood" warning. The engineer who programmed this is a bad person.
The SPA504g emits the correct value with the following configuration:
SIP > RTP Packet Size = 0.02